Q45X (Bus Network) Series

Photoelectric Sensor Selection Guide
Online Learning Contact a Banner Engineer About Your Application

Overview

  • Q45 sensors for direct connection to device-level data bus networks
  • Models for most popular bus protocols including DeviceNet, AS-Interface and SDS
  • Expansion cards for other protocols are possible—contact factory
  • Available in opposed, polarized and non-polarized retroreflective, diffuse, convergent, and glass or plastic fiber optic sensing modes
  • Ranges to 60 m
  • Simple "dumb drop" junction boxes or T-connectors for sensor connection
DeviceNet is a trademark of the Open DeviceNet Vendor Association, Inc.; SDS is a trademark of Honeywell MICROSWITCH Division

Product Specifications

Supply Voltage and CurrentQ45XAB models:depends on Bus Expansion Card used
Q45DN cards:11 to 25V dc @ 60 mA
Q45AS cards:18 to 33V dc @ 45 mA
Q45SD1 cards:11 to 25V dc @ 60 mA
Q45XDN models:11 to 25V dc @ 60 mA
Q45XAS models:18 to 33V dc @ 45 mA
RangeOpposed:60 m
Non-polarized Retroreflective:0.08 to 9 m, range is specified using one model BRT-3 retroreflector
Polarized Retroreflective:0.15 to 6 m, range is specified using one model BRT-3 retroreflector
Diffuse (long range):1.8 m
Diffuse (short range):450 mm
Convergent:38 or 100 mm, depending on model
Plastic and Glass Fiber Optic:Range varies by sensing mode and fiber optics used
Supply Protection CircuitryProtected against reverse polarity, transient voltages and loss of ground. None of these conditions will harm the sensor or interrupt communication on the network.
Response Time2 milliseconds; total response time will also include the response time of the network
AdjustmentMulti-turn sensitivity control on top of the sensor, beneath a transparent polycaronate o-ring sealed cover, allows precise sensitivity setting (turn clockwise to increase gain). Internal switch must be in light operate (LO) position, which is the factory setting.
IndicatorsIndicator LEDs are highly visible, located beneath a raised transparent polycarbonate dome on top of the sensor. Emitters:
Power (Green):lights for dc power is ON
All others:
Power (Green):lights for dc power is ON
Signal (Red):LED lights whenever the sensor sees its modulated light source and pulses at a rate proportional to the strength of the received light signal
Q45DN Bus Card:Green and Red visible through the transparent sensor top cover.
Green ON steady:sensor on line, connected to master
Green ON flashing:sensor on line, address and baud rate are OK
Red ON steady:critical network fault or duplicate node address detected; wrong baud rate
Red flashing:minor or connection time-out fault
Q45SD1 Bus Card:Green and Red visible through the transparent sensor top cover.
Green ON steady:sensor is communicating
Red ON steady:critical fault
Sensor ConfigurationAll Q45XDN models:programmable using the network with a configuration tool
Network address:0-63
Baud rate:125 K, 250 K, 500 K
Operation mode:light operte or dark operate
All Q45XDN models support:
Explicit Message Connection:required to Set and Get sensor Attributes
Q45XDN1 models support:
Bit Strobe Connection:responds to master's request
Q45XDN2 support:
Change of State Connections:which responds to a slave's change of state
I/O Respons is with the following 8-bit word of data:
Bit 0:0—Output is OFF
Bit 0:1—Output is ON
Bit 1:0—Alarm output is OFF
Bit 1:1—Alarm output is ON
Bit 2-7:Not used—always 0
All Q45XAS models conform to the following AS-Interface profile:S-1.1-4.2 Photoelectric Proximity Switches
Data and parameter bits:see data sheet for data and parameter bits that are supported
ConstructionMolded reinforced thermoplastic polyester housing, o-ring sealed transparent Lexan top cover, molded acrylic lenses and stainless-steel hardware.
Environmental RatingNEMA 6P; IEC IP67
ConnectionsQ45XB models:5-pin Mini-style quick-disconnect fitting. QD cables are ordered separately.
Q45XDN models:5-pin Euro-style DeviceNet quick-disconnect fitting. QD cables are ordered separately.
Q45XAS models:4-pin Euro-style AS-Interface quick-disconnect fitting. QD cables are ordered separately.
Operating ConditionsTemperture:
Q45XB models:depends on Bus Expansion Card used
Q45DN cards:-10° to +70° C
Q45AD cards:-25° to +70° C
Q45SD1 card:-20° to +50° C
Q45XDN models:-25° to +70° C
Q45XAS models:-25° to +70° C
Relative humidity:90% @ 50° C (non-condensing)

English

Data Sheets

Document Name Part Number File Size Action
1. Q45X Series, Device Level Bus Networks 37735 244K Download
2. Q45X Series, DeviceNet Bus Networks 46655 647K Download
3. Q45X Series, Expansion Cards for DeviceNet Bus Networks
(45DN)		 39667 493K Download
4. Q45X Series, Expansion Cards for SDS Bus Networks
(45SD)		 39669 184K Download

Sign up for eNews

Industry solutions, application tips, new products, quick video tutorials, trends.

Subscribe Now »

Worldwide Distributors

Banner has more than 2,000 distributors worldwide - ready to help you. Enter a U.S. zip code


Find international distributors