| Supply Voltage and Current | 10 to 30V dc (10% max. ripple)
Diffuse, Retroreflective and Fiber Optic:Less than 25 mA (exclusive of load)
Opposed Emitters and Receivers:draw 20 mA each
|
| Range | Opposed:8 m
Polarized Retroreflective (clear object):100 mm to 2 m, range is specified using one model BRT-3 retroreflector
Diffuse (long range):800 mm
Diffuse (short range):200 mm
Convergent:50 mm
Plastic Fiber Optic:Range varies by sensing mode and fiber optics used
|
| Supply Protection Circuitry | Protected against reverse polarity and transient voltages
|
| Output Configuration | Solid-state complementary (SPDT) dc switch:NPN (current sinking) or PNP (current sourcing), depending on model. The dark operate (DO) output may be wired as a normally open marginal signal alarm output, depending upon hookup to the power supply.
|
| Output Rating | 150 mA max. each output in standard hookup; when wired for alarm output, the total load may not exceed 150 mA
OFF-state leakage current:Less than 1 µA @ 30V dc
Output saturation voltage:less than 1V @ 10 mA dc; less than 1.5V @ 150 mA dc
|
| Output Protection Circuitry | Protected against false pulse on power-up, transient voltages, and continuous overload or short circuit of outputs
|
| Output Response Time | Response time is independent of signal strength.
FPY High-Speed Plastic Fiber Optic:100 microseconds ON/OFF
All other:1 milliseconds ON/OFF
|
| Delay at Power-up | 100 milliseconds; outputs do not conduct during this time.
|
| Repeatability | Repeatability is independent of signal strength.
Opposed:0.13 milliseconds
Retroreflective and Diffuse:0.25 milliseconds
FPY High-Speed Plastic Fiber Optic:25 microseconds
|
| Adjustments | SENSITIVITY control (single-turn, o-ring sealed potentiometer)
|
| Indicators | 2 LED Indicators (except Emitters):
Green ON steady:dc power is ON
Green flashing:output overload
Yellow ON steady:light-operate (LO) output is energized
Yellow flashing:marginal excess gain (1-1.5x), LO output is energized
1 LED Indicator (Emitters only):
Green ON steady:power is ON
|
| Construction | Completely sealed yellow and black ABS housing, with acrylic lenses. Stainless-steel mounting bracket and M3 mounting hardware are supplied.
|
| Environmental Rating | Meets NEMA standards 1, 2, 3, 3S, 4, 4X, 6, 12 and 13; IEC IP67. Housing materials rated UL 94 V-0
|
| Connections | PVC-jacketed 4-conductor 2 m or 9 m cables, or 150 mm pigtail with threaded 4-pin Pico-style quick-disconnect fitting. QD cables are ordered separately.
|
| Operating Conditions | Temperature:-20° to +55° C
Relative humidity:90% @ 50° C (non-condensing)
|
| Application Notes | To avoid damage to the sensor caused by static discharge (ESD), use the plastic screwdriver supplied with each sensor (included in the hardware packet) to adjust the SENSITIVITY control. Otherwise, use a screwdriver with an insulated handle.
|