|Supply Voltage and Current||10 to 30V dc (10% max. ripple)
Opposed Emitters:25 mA (exclusive of load)
Opposed Receivers:20 mA (exclusive of load)
Non-polarized Retroreflective:25 mA (exclusive of load)
Polarized Retroreflective:30 mA (exclusive of load)
Diffuse:25 mA (exclusive of load)
Fixed-field:35 mA (exclusive of load)
Non-polarized Retroreflective:2 m, range is specified using one model BRT-3 retroreflector
Polarized Retroreflective:2 m, range is specified using one model BRT-3 retroreflector
Diffuse (long range):300 mm
Diffuse (short range):100 mm
Fixed-field:0-25, 0-50 or 0-100 cutoff, depending on model
|Supply Protection Circuitry||Protected against reverse polarity and transient voltages
|Output Configuration||Solid-state complementary (SPDT) dc switch:NPN (current sinking) or PNP (current sourcing), depending on model. The dark operate (DO) output may be wired as a normally open marginal signal alarm output, depending upon hookup to the power supply.
|Ouput Rating||150 mA max. (each) in standard hookup. When wired for alarm output, the total load may not exceed 150 mA
OFF-state leakage current::less than 1 µA @ 30V dc
ON-state saturation voltage:less than 1V @ 10 mA dc; less than 1.5V @ 150 mA dc
|Output Protection Circuitry||Protected against false pulse on power-up and continuous overload or short circuit of outputs
|Output Response Time||Response time is independent of signal strength.
Opposed:3 milliseconds ON; 1.5 milliseconds OFF
Polarized Retroreflective, Non-polarized Retroreflective, Diffuse and Fixed-field:3 milliseconds ON/OFF
|Delay at Power-up||100 milliseconds; outputs do not conduct during this time.
|Repeatability||Repeatability is independent of signal strength.
Polarized Retroreflective, Non-polarized Retroreflective, Fixed-field, Diffuse and Fixed-field:750 microseconds
|Indicators||2 LED Indicators:Green and Yellow
Green ON steady:power to sensor is ON
Green flashing:output is overloaded
Yellow ON steady:light-operate (LO) output is energized
Yellow flashing:marginal excess gain (1-1.5x) in light condition, LO output is energized
|Construction||Stainless-steel housing with polycarbonate or acrylic lenses. Two jam nuts are included with each sensor.
|Environmental Rating||Leakproof design rated NEMA 6P; DIN 40050 (IP69K)
|Connections||2 m or 9 m attached cable, or 4-pin Euro-style quick-disconnect fitting. QD cables are ordered separately.
|Operating Conditions||Temperature:-40° to +70° C
Relative humidity:90% @ 50° C (non-condensing)
|Vibration and Mechanical Shock||All models meet Mil. Std. 202F requirements. Method 201A (Vibration; frequency 10 to 60 Hz, max., double amplitude 0.06-inch acceleration 10G). Method 213B conditions H&I (Shock: 75G with unit operating; 100G for non-operation)