| Output Configuration | Output (K1 & K2):two redundant (total of four) safety relay (forced-guided) contacts
Contact rating:
Max. voltage:250V ac/dc
Max. current:4 A ac/dc (resistive load)
Max. power:20 W (1000 VA)
Mechanical life:10,000,000 operations
Electrical life:100,000 at full resistive load
Note:Transient suppression is recommended when switching inductive loads. Install suppressors across load. Never install suppressors across output contacts.
|
| Status Indicators | 1 bicolor Bus Status LED indicator:Red/Green
Green ON steady:On line, connected/allocated to master
Green flashing:On line, not connected/allocated to master; if Autobaud is ON, address and baud rate ok
Red ON steady:Critical network fault or duplicate node address detected
Red flashing:Connection timeout or no power to light screen
OFF:No network power or off line
Green/Red/OFF flashing sequentially:Autobaud detecting network baud rate
1 MAC ID indicator:Yellow
Yellow ON steady:MAC ID address is controlled by the master
Yellow flashing:The address indicated by the MAC ID switches does not match the current address. This indicates that the switch setting has been changed with the device on. This is normal if the user is in the process of changing the address.
OFF:MAC ID address is controlled by the MAC ID switches
ES-TA-3D1 (6 inputs):
20 Green LED indicators:Power ON, K1 energized, K2 energized, ES1-A, ES1-B, ES2-A, ES2-B, ES3-A, ES3-B, ES4-A, ES4-B, ES5-A, ES5-B, ES6-A, ES6-B, Monitor-1, Monitor-2, Monitor-3, Monitor-4, Reset
ES-TA-3F1 (10 inputs):
28 Green LED indicators:Power ON, K1 energized, K2 energized, ES1-A, ES1-B, ES2-A, ES2-B, ES3-A, ES3-B, ES4-A, ES4-B, ES5-A, ES5-B, ES6-A, ES6-B, ES7-A, ES7-B, ES8-A, ES8-B, ES9-A, ES9-B, ES10-A, ES10-B, Monitor-1, Monitor-2, Monitor-3, Monitor-4, Reset
|