| Supply Voltage | Fixed-Field: 10 to 30V dc (10% maximum ripple within
specified limits) at less than 25 mA, exclusive of load
All others: 10 to 30V dc (10% maximum ripple within
specified limits) at less than 18 mA, exclusive of load
|
| Supply Protection Circuitry | Protected against reverse polarity and transient voltages
|
| Output Configuration | 100 mA with short circuit protection
OFF-state leakage current:NPN: < 200 μA sinking;
PNP: < 20 μA sourcing
ON-state saturation voltage:NPN: < 1.6V @ 100 mA;
PNP: < 3.0V @ 100 mA
|
| Output Response Time | Opposed Mode: 1 millisecond ON/600 microseconds
OFF
Fixed-Field: 3 milliseconds ON/1.5 milliseconds OFF
All others: 800 microseconds ON/OFF
Note:100 millisecond delay on power-up; outputs do not conduct during this time
|
| Indicators | Two LED Indicators: Power (green) and Output (yellow)
Fixed-Field models:
Green ON Steady: Power ON
Yellow ON Steady: Black (LO) wire conducting
All other models:
Green ON Steady: Power ON
Green flashing: Output overloaded
Yellow ON steady: Black (LO) wire conducting
Yellow flashing: Marginal excess gain (1 to 1.5X)
Black (LO) wire conducting
|
| Adjustments | Diffuse, Retroreflective, and Polarized Retroreflective
models (only):
Single-turn Sensitivity (Gain) adjustment potentiometer
|
| Repeatability | Opposed Mode: 140 microseconds
Fixed-Field: 182 microseconds
All others: 155 microseconds
|
| Construction | Housing: ABS
Lenses: PMMA
Gain Adjuster: PBT (Retro and Diffuse models only)
|
| Connections | 2 m (6.5') or 9 m (30') 4-wire PVC cable, 150 mm (6
|
| Operating Conditions | Temperature: –20° to +60° C (–4° to +140° F)
Relative Humidity: 95% @ 50° C (non-condensing)
|
| Environmental Rating | IEC IP67 (NEMA 6)
1200 PSI washdown NEMA ICS 5
Annex F-2002
|
| Vibration and Mechanical Shock | All models meet Mil. Std. 202F requirements method 201A (vibration: 10 to 60 Hz max., double amplitude 0.06in, maximum acceleration 10G). Also meets IEC 947-5-2; 30G 11 ms duration, half sine wave
|
| Application Notes | Opposed mode sensor spacing can be reduced by alternating
emitters and receivers or by applying cross talk filters (visible red models only)
|
| Certifications | CE
|