E-Stop Removing and Installing Contact Block [Video]

E-Stop Removing and Installing Contact Block
1 min  2 s 

In this tutorial, we will demonstrate how to remove and install a contact block. This tutorial video is meant as a reference tool only. It was created as a guide to help you through the general steps involved during the installation process. It is important that you read and follow the written installation instructions included with the product and manual found online at BannerEngineering.com.

1 min  2 s 

Transcript

Removing the contact block.

Arm the actuator.

Grip the beveled surface, pull until latch pin clicks.

Rotate contact block counterclockwise.

 

Installing the contact block.

Arm the actuator.

Line up arrows on actuator and bayonet (highlighted for video).

Hold black portion of the contact block. Slide onto actuator and push until fully inserted.

Rotate until yellow bayonet ring pops into position.

 


Featured Products

Auf Konsole montierter Not-Aus-Taster
Auf Konsole montierter Not-Aus-Taster

Elektromechanische 30-mm-Not-Aus-Taster

Read More
Auf Konsole montierter Not-Aus-Taster
Auf Konsole montierter Not-Aus-Taster

Elektromechanische 30-mm-Not-Aus-Taster

Read More