QS30EDV Single-Point Window Teach [Video]

QS30EDV Single-Point Window Teach
1 min  41 secs 

In this video, Banner will demonstrate how to set up a QS30EDV low-contrast sensor, which is designed to detect targets up to 1.4 m and to operate down to 300 microseconds.

1 min  41 secs 

Transcript

This video will show how to set up QS30EDV Low Contrast sensor, which is designed to detect targets out to 1.4 m and to operate down to 300 ms.

Start off by aligning the sensor with the target.

Then press and hold the - button until the number 5 and 6 LED flash.

To set the window, double click the - button.

The sensor is now taught to detect within it's set window.

A higher number on the back of the sensor represents a stronger signal.

To increase the window size, click the + button.

Notice the number 8 LED represents the strongest signal and the number 1 LED represents the weakest signal.

If the sensor fails to teach, you will see the following condition.


Featured Products

QS30 Series High-Performance Long-Range Sensor
QS30 Series High-Performance Long-Range Sensor

High power sensing with ranges up to 200 m, e/m relay output models available.

Read More