cart

QS30ELVC Clear Object Detection [Video]

QS30ELVC Clear Object Detection
1 min  26 secs 

In this video, Banner will demonstrate how to set up the QS30ELVC clear object detection sensor, which is designed to detect clear, translucent and dark targets out to 2 m.

1 min  26 secs 

Transcript

This video will show how to set up the QS30 ELVC Clear Object Detection Sensor, which is designed to detect clear, translucent, and dark targets out to 2 m.

Start off by aligning the sensor with the reflector.

Then press and hold the + button until the top two LEDs flash.

When the LEDs stop flashing, the sensor's threshold is set and the sensor will automatically return to run mode.

The sensor automatically defaults to the dark target mode which allows for the most variation when detecting a clear object.

To adjust the threshold, press the - button until the LED matches the target you want to detect, in this case, the clear bottle.

If the sensor fails to teach you will see the following condition.


Featured Products

QS30 Series High-Performance Long-Range Sensor
QS30 Series High-Performance Long-Range Sensor

High power sensing with ranges up to 200 m, e/m relay output models available.

Read More