DF-G Dynamic Teach

Welcome to a short how-to video that will cover the basics of setting up the Dynamic Teach function of the DFG Fiber Optic Amplifier from Banner Engineering.

To begin, move the mode switch to 'PRG' to access the Program Mode menu.

Use the rocker button to toggle between options until you see the teach selection option, and press down on the button.

Move the rocker button until it says 'dynamic teach', and press the button again.

The display will flash to confirm the teach mode has been changed, and return to the main menu.

To teach the amplifier, move the mode switch to 'ADJ' to access the Adjust mode.

The display will show the current excess gain reading in red, and the current switching threshold in green.

Press down on the rocker button to begin the teach process.

Present multiple on and off conditions to the fiber optic sensor head.

After presenting several conditions to press the rocker button again, the display will show 'Pass', indicating that the new conditions have been taught successfully.

The display will now show the new switching threshold in green, which is calculated based on the on and off conditions that were presented.

If you need to manually adjust this point, use the rocker button to increase or decrease the value.

After selecting a value, leave the rocker button alone for two seconds, and the display will flash to confirm the new set value.

Move the mode switch back to 'Run' to lock in the amplifier settings

That covers the basics of the DFG Dynamic Teach configuration.

For more information, visit our website at bannerengineering.com.