| Supply Voltage and Current | 10 to 30V dc (10% max. ripple) @ 65 mA max (exclusive of load)
|
| Range | 30 to 300 mm
|
| Ultrasonic Frequency | 300 kHz
Rep. rate:2.5 milliseconds
|
| Supply Protection Circuitry | Protected against reverse polarity and transient overvoltages
|
| Output Configuration | 0-10V dc or 4-20 mA, depending on model
|
| Output Rating | 10-30V dc voltage models:2.5 k ohms min. load resistance. Minimum supply for a full 10V output is 12V dc (for supply voltages between 10 and 12, V out max is at least V supply -2)
4-20 mA sourcing models:1 k ohms @ 24V dc input
Max. load resistance:(Vcc-4)/0.02 ohms
|
| Output Protection | Protected against short circuit conditions
|
| Output Response Time | Black wire @ 0-2V dc (or open):30 milliseconds
Black wire @ 5-30V dc:2.5 milliseconds
|
| Delay at Power-up | 300 milliseconds
|
| Linearity | 2.5 milliseconds response:±1 mm
30 milliseconds response:±0.5 mm
|
| Resolution | 2.5 milliseconds response:1 mm
30 milliseconds response:0.5 mm
|
| Temperature Effect | 0.02% of distance/° C
|
| Repeatability | 0.5 mm
|
| Minimum Window Size | 5 mm
|
| Adjustments | Sensing window limits:TEACH-Mode programming of near and far window limits may be set using the push buttons or remotely using TEACH input.
|
| Indicators | Power/Signal Strength (Red/Green):
Green:target is within sensing range
Red:target is outside sensing range
OFF:sensing power is OFF
TEACH/Ouput indicator (Yellow/Red):
Yellow:target is within taught limits
Red:sensor is in TEACH mode
OFF:target is outside taught window limits
|
| Remote TEACH | Impedance:12 k ohms
|
| Construction | Threaded barrel:thermoplastic polyester
Push-button housing:ABS/PC
Push-button:santoprene
Lightpipes:acrylic
|
| Environmental Rating | Leakproof design, rated IEC IP7; NEMA 6P
|
| Connections | 5-conductor (with drain) 2 m or 9 m shielded PVC-jacketed attached cable, or 5-pin Euro-style quick-disconnect fitting. QD cables are ordered separately.
|
| Operating Conditions | Temperature:-20° to +60° C
Relative humidity:100%
|
| Vibration and Mechanical Shock | All models meet Mil. Std. 202F requirements. Method 201A (Vibration: 10 to 60 Hz max. double amplitude 0.06”, maximum acceleration 10G). Also meets IEC 947-5-2 requirements: 30G, 11 milliseconds duration, half-sine wave.
|
| Temperature Warmup Drift | Less than 1.7% of sensing distance upon power-up
|
| Application Note | Objects passing inside the specified near limit may produce a false response.
|