
Measure Distance Without an Analog Sensor
Pulse Pro I/O sends digital pulses that are proportionally scaled across the measuring span on the sensor. This allows users to use a high-quality digital input card on their PLC to determine the measured distance. The sensor will indicate a loss of signal between the sensor and target, providing additional information to customers about target presence and absence. Pulse Pro I/O’s digital signal has increased immunity from electrical noise interference, a common problem of analog transmissions over long cable runs, so it does not require shielded cabling.
Superior Performance over Distance
Reduce costly, unplanned downtime with compatible Banner lights that assist operators with high-visibility, at-a-glance operator guidance and status indication. The unmistakable illumination streamlines factory communication by promoting faster response to status changes and reduces the risk of costly mistakes and accidents. For example, the TL50 Pro tower light shows material level so that reloads or unloads can be handled timely and efficiently. Additionally, WLS27 Pro strip lights show separation distance between moving equipment like AGVs.
Complete Plug-and-Play Solution
Utilize technology compatible with a wide and expanding range of Banner’s smart sensors. The range of products used for Pulse Pro I/O solutions allows users to create a solution that meets the needs of any application. The PFM output is available on select Q4X, Q5X, and LTF series IO-Link models. Sensors indicate long-, mid-, and short-ranges that can be seen across the factory floor. Users can visualize incremental changes in precision applications or direct operators of large machines and equipment.
Pulse Pro I/O is used in a wide variety of applications where immediate visibility is necessary, including, but not limited to:
- Dashboard assembly process
- Operator scale interface
- Checkweigher status visibility
- Coil level
- Material level in hopper
- Part in place confirmation
- Roll diameter and symmetry
- Forklift/AGV guidance