• Voltar

    • Sample Timers for DXM1x0-Bx Models

    Overview

    Using a vibration sensor is a good way to determine if an asset is running or not. When an asset is running, the vibration should be at a much higher level than when it is idle. By monitoring the vibration, and setting a threshold at a certain level, it is possible to determine if the asset is running or not.

    The following sensors can be used to monitor vibration:
    QM30VT1
    QM30VT2
    DX80NxQ45VA

    Ensure to use a compatible radio with the QM30 sensors. The QM30VT2 may also be wired directly to the DXM.

    The associated XML sample programs can be loaded into a DXM150-Bx or DXM100-Bx Wireless Controller.


    The Sample Timer XML provides an example of a continuously running timer that resets at different time intervals. It does not require remote radios connected to the DXM1x0 to function. The timer is always running. The DXM display LEDs are enabled by universal input 1 on the DXM100 and isolated input 1 for the DXM150. The input is labeled LED Enable. When the LED Enable inputis active, LEDs 1, 2, and 3 on the DXM turn on for 5, 10, and 20 seconds respectively as defined by Action Rules. The timer automatically resets at 25 seconds, then LEDs 1, 2, and 3 are again turned on. This ongoing timer can be used for OEE applications, etc.

    One-shot Timer XML provides an example of a timer sequence started with the rising edge transition of the Input Trigger. The Input Trigger is universal input 1 on the DXM100 and isolated input 1 for the DXM150.


    All timer and input values can be observed via the display of the DXM.

    Using a Vibration Sensor to Determine if an Asset is Running
    Using a Vibration Sensor to Determine if an Asset is Running
    zip
    Download All Files
    Adicionar à Minha Biblioteca
    Adicionado